SENukeTNG

Before integrating a proxy into SENukeTNG, make sure you have set up the proxy correctly to guarantee that the proxy service will work properly.

1. Open ProjectMaker in the ZennoPoster application to create or edit your project.

2. If you already have a project, click the "Open" button. If you are creating a new project, click the "Record" button.

3. Then click on the Proxy tab and you can see the available proxy settings on the page. To use a custom proxy on this application, check the Use proxy option.

4. When the "Use proxy" option is selected, the radio button will become visible. Click the "Custom Proxy" option and then click the "Add Proxy List" button.

5. If you are not using a whitelist IP, be sure to fill in your proxy username and password.

6. Now you can add proxies to the list. Depending on your needs, you can select a specific endpoint or the entire list of proxies generated on the 711 Proxy Dashboard.

7. When the proxy list is ready, click the "Add Proxy List" button to continue the setup.

8. At this point, your proxy is ready for use. However, if you want to be sure, you can also run a check by clicking the "Test Proxy" button in the proxy settings.

9. After completing the proxy or general settings test, click "Save".

Follow the steps above and your proxy is now configured.